g software, such as EZ drive or Disk Manager, installed. If you do, restart your computer and run Setup from an MS-DOS command prompt. For more information, see "Installing Windows ME from MS-DOS."Standard Mode Messages----------------------If you get any of the following error messages, remove any memory managers (such as EMM386.exe, QEMM, or 386Max) from your Config.sys file, and then run Setup again. Standard Mode: Invalid DPMI return. Standard Mode: Fault in MS-DOS Extender. Standard Mode: Bad Fault in MS-DOS Extender. Standard Mode: Unknown stack in fault dispatcher. Standard Mode: Stack Overflow.NOTE: If you still have problems, add EMM386.exe back into your Config.sys file and exclude all ranges. For example:device=c:windowsemm386.exe x=A000-FFFFIf you encounter these messages or if your computer stops responding during Setup, turn on double-buffering in SmartDrive. Several SCSI hard drives and some ESDI drives require double-buffering.To turn on double buffering, add the following line to the beginning of your Config.sys file:device=c:windowssmartdrv.exe /double_buffer+where "c:windows" is the path to your Windows directory."Setup Could Not Back Up Your System Files" Message---------------------------------------------------If you see this error message while Setup is saving your system files, you may not have enough disk space, particularly on compressed disks. Free up space on the drive you are saving your system files on (the default drive is C) by removing unneeded files.Uninstall can require up to 110 MB on many systems. If Setup is not offering you the choice of saving your system files, you may be very low on free disk space."Cannot Continue on This System Configuration"----------------------------------------------If you get this message, you may have an older, incompatible disk partition. Before you run Setup, you will need to back up your data and then repartition your disk.Message SU0167-----------...
