p should easily snap off. Another way to snap off the head is to take the lid of a pen, stick it on the top of the amp's 'head', and simply snap it off.There are also websites on the internet that sell amp openers that make the process even easier, a search on yahoo should find the device.Actual Injection Procedure:1. Take an alcohol swab should be used to clean the injection site and the rubber stopper on top of the vial, which will be drawn from. 2. Take a brand new syringe out of its wrapper, remove its plastic top, draw about 2 ccs of air into it and insert it into the vial. Inject this air into the vial; this creates pressure within the vial and makes it easier to draw out the solution. 3. Turn the vial upside-down and slowly draw out the solution until you have approximately .5 cc more than you need for the injection. 4. Tap the syringe case to help the air bubbles rise to the top near the needle. Simply push the plunger upward, pushing all the air out of the syringe, and into the vial. Then push the remaining extra solution you are not using back into the vial. Remove the needle from the vial. Then, hold the syringe needle-side-up and continue to tap it to encourage all the air bubbles to come to the top of the syringe. 5. Now, take another clean syringe, remove it from its sterile package and unscrew the needle from the syringe. Exchange the brand new needle for the one that has just been injected into the stopper. By using two needles for every injection, you can take advantage of using the full sharpness of the pin. The needle does suffer some dulling when it is pushed through the firm rubber stopper on a vial. It is important not to touch this needle before the injection. It should not come into contact with a counter top, your fingers, nor should it be cleaned with alcohol. This needle is sterile and should not be touched. 6. Once again swab the injection site with alcohol, and then press the stopper of the syringe holding i...
